ARpiCADE Forums

MikeH482

Spoke too soon. Mame games work fine. But the console games I tested (Super Nintendo) freeze during boot. Not sure why.

MikeH482

Dylan - sorry for the super delayed response. I missed your reply end didn’t get a notification from the forum. My apologies. The updated firmware seems to work fine on all 4 of my arcade setups (2 vertical, 2 horizontal), which are all classic jamma cabs with CGA standard resolution monitors (19” K...

MikeH482

Recently bought a new Raspberry Pi 3B+ to do a new Arpicade install. Cloned my working micro SD card. The card would not boot in the new RPi3B+ (green led on Pi gave an error code of 4 long flashes and 7 short flashes). After many hours of troubleshooting and reordering 3 (yes 3) RPi3B+ boards (to r...

MikeH482

@triggerhappy

Thank you for sharing this. Worked perfectly for me for my Tron/Discs of Tron with joystick and spinner controls. I really appreciate this community and people sharing solutions and troubleshooting results. Thanks!

MikeH482

Tried your suggestions regarding the ResSwitch.sh file and went down a bit of a rabbit hole but I'll sum it up. Hashing out or deleting those lines in the ResSwitch.sh file took care of the refresh issues, but introduced resolution issues where most of the games only displayed in the center third of...

MikeH482

Thanks @dee2eR! I will try those options and report back. Instead of hashing out those lines in the ResSwitch file, can I just delete them? If so, that would be a fast way for me to test it. I'll be sure to make a backup of the file to revert to if needed. MAME2003_Plus is a good emulator but becaus...

MikeH482

I tried all the above and the only thing that works is adjusting the monitor's horizontal and vertical hold pots. But then that messes up the display on all the other games that were displaying fine previously, and even the AttractMode frontend is out of sync. Not sure what else to try or maybe just...

MikeH482

UPDATE: It turned out the DAC went bad. Tested this by bypassing the ArPiCade board's video connection and connecting the Pi directly to an HDMI monitor and it would display fine, then tested using the DAC into a VGA monitor would display nothing. I suspect that the 5volts on my switching power supp...

MikeH482

Two questions here: 1. I want to use MAME2003 emulator, not MAME2003-PLUS. What do I need to change in order for it to use the original MAME2003 emulator? I'm running the 3.X software on a Pi3b. 2. Is there a way to force a game (or all games) to run at 60hz instead of the games native refresh rate?...

MikeH482

Any idea what setting(s) I might need to adjust? Refresh rate?

Search found 13 matches

Re: RPi Firmware update for Pi's mid 2023 and newer

Re: RPi Firmware update for Pi's mid 2023 and newer

RPi Firmware update for Pi's mid 2023 and newer

Re: Rotary controller

Re: Switch back to MAME2003 and how to force refresh to 60

Re: Switch back to MAME2003 and how to force refresh to 60

Re: Refresh or Sync problem with some games

Re: RaspberryJAMMA fried? HELP!

Switch back to MAME2003 and how to force refresh to 60

Re: Refresh or Sync problem with some games